New Holland LS140 Workshop Manual page 600

Hide thumbs Also See for LS140:

Table of Contents

SECTION 82 - FRONT LOADER (BOOM AND MOUNTING PLATE)

6. Position the first plates against the back of the

bucket at 1, and rest on the quick-attach plate, 2.

Locate the center of the latch plate notches, 4,

and center the outer half of the notch over the

latch pin, 3. Spot weld the plate to the bucket at

1 to hold the plate in position.

NOTE: The material to be welded is low carbon,

grade 50 steel; use welding rods marked 6011 or

7. Position the second plates as shown at 1, with

the plates contacting each other at 2, and about

28.6 mm (1-1/8") spacing at 3. On low-profile

buckets, the second plate will be at the rear cor-

ner of the bucket at 4. Spot weld the second plate

to the bucket at 4 and the two plates together at

8. Remove the 4.8 mm (3/16") square key stock

and push the latch handles to the latched position

making sure the latch pins engage the bucket

latch plates. The latch handles must fully latch.

The latch pin will only contact the top latch plate,

9. If the latch handles will not fully latch, the top

plate may require some grinding in the pin area

at 1, or the plates are not located properly.

Chapters

Table of Contents