New Holland LS140 Workshop Manual page 260

Hide thumbs Also See for LS140:

Table of Contents

2. Insert the button rod, 1, spring, 2, and flat washer,

3, into lever at 4.

3. Insert the new style latch plate, 5, and bushing,

6, with the extended area, 7, as shown to the rear

(engine side) of lever and position the button rod

so the hook is back of the latch plate at 8. Rein-

stall the two retaining bolts, nuts and washers,

through the lever assembly and the control rod.

Spring Reassembly

1. Reassemble the spring, 1, rod weld assembly, 2,

and spring plate, 3.

2. Compress spring, 1, and plate, 3, enough to

clamp vise grips onto end of rod weld assembly,

2, at 4 to install roll pin, 5.

3. Install roll pin, 5.

4. Thread rod assembly, 6, into rod weld assembly,

5. Adjust the spring assembly length by threading

rod, 1, in or out, to obtain an overall length of

8-5/8" at 7.

SECTION 33 - BRAKES AND CONTROLS

Chapters

Table of Contents