Checking Procedure - New Holland LS140 Workshop Manual

Hide thumbs Also See for LS140:

Table of Contents

SECTION 82 - FRONT LOADER (BOOM AND MOUNTING PLATE)

CHECKING PROCEDURE

The following are the procedures used to measure

the skid-steer loader faceplate and how to measure

the attachment.

Checking the Attachment

1. Check the placement of the lower latch plates at

1. Measure from the back surface of the attach-

ment to the rear of the latch plate slot at 1: 35.8

mm ± 0.8 mm (1-9/32" ± 1/32").

a. If this dimension is too short, the slot can be

widened by grinding out the slot 1/16" maxi-

mum or replace the latch plates.

If grinding is required, the rear of the slot must be

ground square with the top surface of the plate to

ensure proper pin engagement, 2, Figure 86.

b. If the dimension is too long, replace the latch

2. Check the height of the attachment at 2. Insert a

1/2" x 2" with 1/2" standard nut as shown at 3.

Measure from the top of the bolt, 4, to the rear of

the latch plate slot at 5: 403.2 mm ± 0.8 mm

(15-7/8" ± 1/32").

If this dimension is incorrect, the lower latch plates

will require replacement.

NOTE: If new latch plates are required, order four

plates #86506587 (102 mm, 4, slot) through Parts

and follow the latch plate installation procedure.

Table of Contents