New Holland LS140 Workshop Manual page 436

Hide thumbs Also See for LS140:

Table of Contents

A completely new auxiliary wiring circuit can be

installed as shown in Figures 5 and 6, depending on

electrical requirements. Mounting holes for the

added circuit breakers must be drilled in the panel.

Disconnect the battery before drilling and installing

components from drilling shavings that could cause

electrical shorting of components. Figure 4 shows

circuits for intermittent high current loads up to 15

Figure 6 shows the circuit for intermittent high current

loads up to 30 amps.

New Holland sealed circuit breakers that can be

purchased from parts.

NOTE: When attaching ground wires, always place

the heaviest ground wire next to the ground surface

and then stack the remaining ground wires according

to size on top of the heaviest wire.

IMPORTANT: Additional electrical attachments must

have circuits properly connected to prevent damage

to the Advanced Warning System (EIC board) and

other electrical components.

Always disconnect the battery before installing

any electrical attachment to prevent accidental

shorting of system.

SECTION 55 - ELECTRICAL SYSTEM

Chapters

Table of Contents