New Holland LS140 Workshop Manual page 284

Hide thumbs Also See for LS140:

Table of Contents

SECTION 35 - HYDRAULIC SYSTEM

Adjustments Control Handle Locked, 1, In

Adjust the length of rod, 2, by threading the ball joints,

3, on or off, at both ends of the rod to set the link, 4,

vertical. Check adjustment by shifting the hydrostatic

control lever forward and reverse. If the rod length is

set correctly, there should be no movement in the

link, 4, as the rod, 5, moves.

With the control handle locked in neutral and the con-

trol valve spool centered in the neutral position, ad-

just the length of rod, 6, with yoke, 7, to allow the

installation of the yoke pin.

When the skid steer is operated, there should be no

noise in the hydraulic system when in neutral.

NOTE: When using a hydraulic attachment, all oil

must be returned through the standard return system

to provide charge oil to the hydrostatic system.

IMPORTANT: If sufficient oil is not provided for the

hydrostatic system, severe damage to the hydrostat-

ic system will occur.

Chapters

Table of Contents