New Holland LS140 Workshop Manual page 173

Hide thumbs Also See for LS140:

Table of Contents

6. Raise the operator's seat and latch in the raised

position, 1.

Never work under a raised seat unless it is se-

curely latched in the raised position.

7. Remove the step shield, 2, to access the hydro-

static pump area. For more access, remove the

right and left hydrostatic control handle assem-

8. Relieve all pressure in the hydraulic and hydro-

static systems.

Never loosen any hydraulic lines without first re-

lieving all pressure in the systems to avoid seri-

Draining the hydraulic oil reservoir is not required

if the suction and return lines are capped to pre-

vent loss of oil. If the hydraulic system requires

cleaning, draining is required.

9. Remove the rear engine belly pan, 1.

Use a floor jack to support the belly pan to pre-

vent serious injury.

10. Drain the hydraulic reservoir.

a. Loosen the return line clamp, 1.

b. Remove the return line at 2, and rotate the

line into a suitable drain pan.

SECTION 29 - HYDROSTATIC TRANSMISSION

Chapters

Table of Contents