New Holland LS140 Workshop Manual page 540

Hide thumbs Also See for LS140:

Table of Contents

4. Place the main wire harness to the front side of

the boom lock linkage at 1, and reinstall the wire

5. Route the wire harness to the front of the loader

on the left side and install wire clamps where

previously installed. Place the harness into the

loop (keeper) and secure with a wire tie at 1, and

then along the top of the lower frame to the rear

of the loader to the engine fuse/relay panel area.

6. Route the harness branch to the inside of the

frame with the hydraulic lines and down to the

floor and front of the control valve. Refasten in

the J clamp and route the connectors between

valve bosses and plug in solenoids. Tuck the

connectors between valve bosses to protect the

7. Connect the main wire harness connector, 1, to

the engine wire harness. Reconnect the wires to

the proper components in the panel, 2.

8. Reconnect the wires to the fuel tank sender, 3.

Route the harness in the groove in the fuel tank

at 4. Reconnect the electric fuel pump power

wires and ground, 5. Reconnect the wires to the

air cleaner restriction switch, 6.

NOTE: Refer to "Removal, Installation and Wiring of

Electrical Components" earlier in this section for

more details of proper wire connections.

SECTION 55 - ELECTRICAL SYSTEM

Chapters

Table of Contents