General Information; Adapting Attachments Requiring 12V Electrical Power - New Holland LS140 Workshop Manual

Hide thumbs Also See for LS140:

Table of Contents

GENERAL INFORMATION

ADAPTING ATTACHMENTS REQUIRING

12V ELECTRICAL POWER

There are important rules that must be followed when

adapting attachments that require 12 volt electrical

power. Proper wiring of electrical devices and power

and ground connections is very important to prevent

other electrical component damage. Attaching elec-

trical connections to locations other than recom-

mended may allow electric current to feed back

through the EIC board, creating false EIC board

readings and warnings, or causing EIC board dam-

age or failure.

1. ALWAYS FOLLOW the instructions for New Hol-

land kit installation to ensure proper function and

2. NEVER CONNECT an electrical device to any

wires, fuses, switches or grounds inside the cab

area. This includes any terminals of the ignition

switch, fuse panel, or ground terminal.

3. NEVER INSTALL an electrical device, music ra-

dio, two-way radio, or unapproved New Holland

attachment into the cab area.

4. ONLY USE the 12-volt accessory power outlet

for attachments requiring less than 10 amps. The

accessory outlet is connected to the engine fuse/

relay panel and protected with a 15 amp fuse.

5. ALWAYS CONNECT new electrical attachments

to the engine fuse/relay panel, 1, and connect the

grounds to the engine bell housing. USE ONLY

vacant connections and fuses not in use for spe-

cified attachments.

SECTION 88 - ACCESSORIES

Table of Contents