New Holland LS140 Workshop Manual page 227

Hide thumbs Also See for LS140:

Table of Contents

1. Inspect the handle pivot bearings, 1; replace if

worn or damaged.

2. Inspect the control handle for excessive wear or

bends in the bearing mounting plates, 2, and piv-

ot stub shafts, 3.

1. Slide the handle sideways over the stub shafts.

2. Install the bearings, 1, on the handle. Install shim

washers, 2, to center the handle in the slot, 3.

3. Install shim washers, 4, to reduce side play on

the stub shafts. Retain the shims on the stubs

shaft with a roll pin, 5.

4. Slide the boot, 6, over the handle and tighten the

boot securing bolts.

5. Install a new hand grip, 7, if grip is worn.

REINSTALLATION

1. Place the handle assembly in the unit and install

the five handle mounting bolts, 1, and tighten se-

SECTION 29 - HYDROSTATIC TRANSMISSION

Chapters

Table of Contents