New Holland LS140 Workshop Manual page 186

Hide thumbs Also See for LS140:

Table of Contents

6. Insert the needle bearing, 1, and inner race, 2,

over the short shaft end of the cam plate. The

numbered end of the race and bearing should

face outward, 3, and the chamfered ID of the race

inward. Install washer, 4; new O ring, 5; end

plate, 6; and outer cover plate, 7, and torx

7. Install bearing, 1; washer, 2; new seal, 3; and out-

er cover plate, 4, with torx screws. Tighten all four

torx screws to 4.8 N·m (40 in. lbs.).

NOTE: After the cover plate hardware is tightened,

the covers may have a slight bow, especially the top

cover over the lip seal.

8. Install retaining ring, 1, on shaft. Install thrust

washer, 2; thrust bearing, 3; and second thrust

washer, 4. Secure with second retaining ring, 5.

SECTION 29 - HYDROSTATIC TRANSMISSION

Chapters

Table of Contents