New Holland LS140 Workshop Manual page 24

Hide thumbs Also See for LS140:

Table of Contents

15. Loosen the front cab mounting bolts, 1, only

enough to allow the bolt to rotate in the support.

Remove the rear front cab bolts, 2.

Never remove the front cab bolts, 1, as these are

the pivot bolts during the cab tilting procedure.

Removal of these bolts could cause the cab to fall

and may cause injury and machine damage.

16. Remove the two rear cab post bolts, 1.

Never loosen or remove any cab retaining

hardware before the jack assembly is installed.

17. Jack cab and boom assembly over with the skid

steer properly supported off the ground. Support

the boom at 1, to prevent tipping of the skid steer

when heavy components, engine, hydrostatic

pumps, etc. are removed from the lower frame.

Jack travel or length of hydraulic hoses will limit

the travel of the cab assembly when tilting. Be

sure all wire harnesses, hydraulic hoses, and

throttle cable clear any obstructions during cab

Never attempt to tilt the skid steer cab without

proper instructions and without using the proper

Never attempt to operate or move the skid steer

without first installing and properly tightening all

cab retaining hardware.

SECTION 00 - GENERAL INFORMATION

Chapters

Table of Contents