New Holland LS140 Workshop Manual page 499

Hide thumbs Also See for LS140:

Table of Contents

Op. 55 301 40

1. Raise the boom and rest it on the boom lock pins,

Never work under a raised boom unless it is

properly supported by the boom lock pins.

2. Open the rear door, 2, raise the top hood, 3, and

remove the right engine side shield, 4, to access

the battery.

3. Disconnect the negative (–) battery cable, 1.

4. Disconnect the positive (+) battery cable, 2.

5. Loosen the top muffler support hardware at 3,

and remove the lower support hardware at 4, and

pivot the support in towards the engine.

6. Remove the battery hold-down hardware, 5, and

remove the battery from the loader.

INSTALLATION

1. Orient the battery with the positive post, 2, toward

the rear of the loader. Install the battery and the

hold-down strap and hardware. Position the

hold-down strap to clear other components.

2. Connect the positive (+) RED cable to positive (+)

terminals and negative (–) BLACK cable to

negative (–) terminals. Do not over tighten.

Observe the tightening specifications on the

battery label.

IMPORTANT: Crossing of terminals may cause

damage to the electrical system, alternator and

Advanced Warning System (EIC).

3. Install protective caps over the battery terminals

and cable connections.

SECTION 55 - ELECTRICAL SYSTEM

Chapters

Table of Contents