New Holland LS140 Workshop Manual page 358

Hide thumbs Also See for LS140:

Table of Contents

8. Remove the fan shroud retaining hardware, 1, to

access the oil cooler.

9. Remove the oil cooler, 2, retaining hardware to

separate the cooler from the radiator.

1. Reattach the oil cooler to the support with the

previously removed hardware.

2. Reinstall the support with the oil cooler and radia-

tor attached into the frame.

3. Position the support square with the loader frame

at 1, and install retaining hardware and tighten

4. Reconnect the hydraulic lines to the cooler.

Tighten the lines to seat to fittings, then loosen

lines and retorque.

5. Reconnect the radiator lines and refill cooling

system with 50/50 water-antifreeze mixture.

6. Reconnect the filter hydraulic lines. Tighten the

lines to seat to fittings, then loosen lines and re-

7. Reconnect the filter sensor wires.

8. Check hydraulic oil level and add 10W-30 oil if re-

9. Start the unit, operate the hydraulic system,

check for oil leaks and coolant leaks, and repair

as required.

10. Check the oil level and engine coolant level and

add as required.

SECTION 35 - HYDRAULIC SYSTEM

Chapters

Table of Contents