EIC (Electronic Instrument Cluster) BOARD
REMOVAL
Op. 55 418 10
1. Disconnect the negative (–) battery cable.
2. Remove the retaining hardware, 1, and remove
the EIC board from the overhead dash area.
3. Unplug the two wire harness connectors, 1, from
the EIC, taking care to not stress or bend the
plastic locking ramps on the connectors. Use a
plastic card (credit card) to assist in unlocking the
lock ramps.
NOTE: Note the positioning of the connectors to the
EIC board and reconnect to the new board in the
correct position. If the connector is not connected
properly, damage to the EIC may occur.
SECTION 55 - ELECTRICAL SYSTEM
55-75
Copyright © New Holland
1
80
81