New Holland LS140 Workshop Manual page 610

Hide thumbs Also See for LS140:

Table of Contents

SECTION 82 - FRONT LOADER (BOOM AND MOUNTING PLATE)

6. Loosen the front lower link pivot pin retaining

hardware, 1, and strike the link at 2, to break the

tapered pivot pin loose in the ROPS frame.

7. Remove the retaining pin hardware, 1, from the

front and rear pins. Lift the lower link and pins

from the loader.

NOTE: Both the right and left lower links can be re-

moved as described.

Op. 82 100 53

Upper Link Removal

1. The boom must be properly supported at the

front and rear of the boom with the boom in the

lowered position or with the front of the boom

above the front upper link pivot. Remove all hy-

draulic oil pressure from the boom and bucket hy-

draulic circuits.

NOTE: Supporting the boom will keep the boom in

position during the removal of the upper links.

Always use a suitable lifting device and chains or

straps to support and remove the boom.

2. Loosen the rear link retaining bolt, 1; do not re-

move. With a soft-faced sledge hammer, strike

the link at 2, to break the tapered pivot pin loose

in the main boom.

Chapters

Table of Contents