Seat, Switch And Pan Reinstallation - New Holland LS140 Workshop Manual

Hide thumbs Also See for LS140:

Table of Contents

SECTION 90 - PLATFORMS, CAB, BODYWORK, AND DECALS

SEAT, SWITCH AND PAN REINSTALLATION

1. Install the switch(es) into the seat pan, making

sure the switch is seated into the hole in the seat

IMPORTANT: If the switch is not seated properly

when the retaining hardware is tightened, the switch

flange will be broken.

2. Reconnect the wire harness to the switch(es)

and reinstall the seat retaining hardware. Make

sure the harness connector latches are

3. Reattach the seat to the seat pan support with

retaining hardware at 1.

NOTE: If the seat/seat belt wire harness was

removed, reinstall the wire grommet in seat pan at 2,

and wire clamp on back of seat, 3, to retain the wire

4. Reinstall the seat and seat pan support assembly

into the skid steer and attach with hardware at 1.

If the seat pan latch rod, 2, or latch plates, 3, were

removed, they may require adjustment to ensure

proper seat latching.

Table of Contents