General Specification - Recommended Engine Oil For Operating Temperature Ranges - New Holland 200 Series Service Manual

General specification - Recommended engine oil for operating
temperature ranges
NEW HOLLAND CONSTRUCTION prefers the use of NEW HOLLAND AMBRA UNITEK MASTERGOLD SBL CJ-4
engine oil in your engine. This multi-viscosity oil will lubricate your engine correctly under all operating conditions.
NEW HOLLAND AMBRA UNITEK MASTERGOLD SBL CJ-4 engine oil has a maximum service change interval of
600 h.
You may use other engine oils if the engine oils meet API CJ-4 performance requirements.
NEW HOLLAND CONSTRUCTION engine oils exceed API CJ-4 performance requirements.
See the following chart for recommended viscosity at varying ambient air temperature ranges.
NOTE: Do not put performance additives or other oil additive products in the engine crankcase. NEW HOLLAND CON-
STRUCTION develops the oil change intervals given in this manual from tests with NEW HOLLAND CONSTRUCTION
lubricants.
For machines with Tier 4B (final) engines
(H)
(H)
-40 °C -30 °C
-40 °F -22 °F
(H) NEW HOLLAND CONSTRUCTION recommends the use of an engine oil pan heater or coolant block heater in
this range.
0W-40 CJ-4 UNITEK to CNH MAT3521
(H)
10W-40 CJ-4 UNITEK to CNH MAT3521
(H)
(H)
(H)
-20 °C -10 °C
-4 °F 14 °F
INTRODUCTION
0W-40 API CJ-4
10W-40 API CJ-4
15W-40 CJ-4 to CNH MAT3522
15W-40* API CJ-4
0 °C 10 °C
32 °F 50 °F
48068128 29/01/2018
30
20 °C 30 °C 40 °C
68 °F 86 °F 104 °F
50 °C
122 °F