New Holland LS140 Workshop Manual page 242

Hide thumbs Also See for LS140:

Table of Contents

27. Attach the ball end and jam nut, 1, onto rod, 2.

Install spacer, 12, (OD - 7/16"; length - 15/32")

between the ball end and arm, 3. Secure with a

5/16" x 1-3/4" bolt, lock washer, and nut at 4.

28. Install shim washers at 5, between the cotter pin,

6, and bearing, 7, to center rod, 2, in the control

handle tube at 8. Secure the cotter pin and slide

the set collar, 9, against the opposite bearing to

remove any side movement of the shaft and tight-

en the setscrew.

29. Drive the groove pin, 12, in the arm completely

30. With the handle in the neutral position angle, ad-

just the length of the rod, 2, so the ball stud at the

arm, 3, aligns with the pivot bearings at 10. This

will also set the pivot arm, 11, in a vertical posi-

31. Rotate the handle to make sure the rod, 2, does

not interfere at the top or bottom of the control

handle tube. Move the control handle back and

forth (forward and reverse) and make sure the

control arm, 3, does not move. When there is no

movement, tighten the jam nuts at both ends of

REINSTALLATION

1. Place the handle assembly in the unit, install the

handle mounting bolts, 1, and tighten securely.

2. Install the auxiliary hydraulic control or bucket

control rod, 1, on the right control handle arm, 2.

SECTION 29 - HYDROSTATIC TRANSMISSION

Chapters

Table of Contents