TESTING OTHER EIC FUNCTIONS
NOTE: These tests are performed with the EIC in the
normal operating mode and the "SERVICE/RUN"
switch in the "RUN" position.
1. Parking Brake Light
Sit in the seat with the seat belt buckled. After the
EIC board self test, the parking brake light, 1,
should flash. Turn the ignition key to the "ON"
position and the light should go off. If the light fails
to go off, check the 5-amp fuse in the cab fuse
panel.
When exiting the skid steer with the ignition key
in the "ON" position, the light should flash for
about 2 seconds after the seat belt is unbuckled
and the operator is out of the seat.
If the light does not flash when the seat belt is
unbuckled, check operation of the seat belt
switch and the seat switch.
2. Seat Belt Light
Sit in the seat. After the EIC board self tests, the
seat belt light, 1, will flash until the seat belt is
buckled.
If the light continues to flash after the seat belt is
buckled, check operation of the seat belt switch.
SECTION 55 - ELECTRICAL SYSTEM
SM463-39
SM463-40
55-54
Copyright © New Holland
53
54