New Holland LS140 Workshop Manual page 208

Hide thumbs Also See for LS140:

Table of Contents

REINSTALLATION

1. Clean all previously sealed surfaces; motor

mounting flange, seal plate, hardware and chain

case opening, final drive cover, brake discs re-

taining bolts and washers.

When resealing, use a noncorrosive silicone

sealer to prevent rust and corrosion of parts after

2. Place a bead of New Holland Ultra-Blue silicone

sealer around the face of the motor mounting

flange, 1, the inner face of the seal plate at 2, and

under the heads of the motor attaching bolts.

3. Align and install the motor and seal plate in the

chain case side sheet. Install the attaching bolts,

drawbolt adjusters, 3, lock washers and nuts, 4.

Do not tighten at this time.

4. Install drive sprocket, 1, and retain with the snap

ring at 2, that was previously removed. Install pri-

mary drive chain, 3. This chain has no connector

5. Adjust the motor drawbolts to obtain a

6mm (1/4") chain deflection with a 4.5 kg (10 lbs)

force at the center of the chain span. Tighten the

motor mounting hardware, 4, to 101 N·m (75 ft.

6. Reseal the brake assembly retaining bolts and

install the brake discs, 1, and calipers, 2. Retain

the discs to the shaft with retaining ring, 3.

7. Torque the brake assembly retaining bolts to 46

N·m (34 ft. lbs.).

SECTION 29 - HYDROSTATIC TRANSMISSION

Chapters

Table of Contents