New Holland LS140 Workshop Manual page 330

Hide thumbs Also See for LS140:

Table of Contents

5. Install the seal, 1, and backup gasket 2, on the

wear plate, 3. BE SURE that the flat area, 4, on

the gasket AND seal, 5, are properly aligned and

lay flat when installed in the wear plate.

NOTE: The gasket AND seal must align and lay flat

at 4 when installed in the wear plate.

6. Install the wear plate assembly, 1, with the gas-

ket/seal side towards the pump front plate, into

the body cavity with the mid section cut away on

the suction side (large half moon cavity), 2, of the

NOTE: To best accomplish the installation of the

wear plate, hold the pump body/front plate assembly

upside down while sliding the wear plate assembly

up into the housing until it is seated against the front

plate. This helps ensure that the seal and backup

gasket stay in place.

SECTION 35 - HYDRAULIC SYSTEM

Chapters

Table of Contents