New Holland LS140 Workshop Manual page 265

Hide thumbs Also See for LS140:

Table of Contents

3. Install spacer plate, 2, next to the end of the shaft.

Install the thick steel brake friction puck, 1.

NOTE: NOTE: The thin spacer plate must be in-

serted into the caliper support first, then the friction

puck, to ensure proper brake operation.

4. Install the inside brake disc, 1, onto the splined

motor coupler shaft.

5. Put a bead of silicone sealer around the caliper

retaining bolts and insert in support.

6. Slide the spacers, 2, and center caliper, 3, over

7. Install the outer brake disc, 1, on the motor shaft.

8. Thread the caliper retaining bolts, 2, into the out-

er caliper, 3, and tighten to 70 N·m (52 ft. lbs.).

SECTION 33 - BRAKES AND CONTROLS

Chapters

Table of Contents