New Holland LS140 Workshop Manual page 393

Hide thumbs Also See for LS140:

Table of Contents

5. The outer axle seal, 1, may be replaced at this

time without further disassembly. The seal can

be replaced without removing the bearing, 2.

6. Install a bearing separator/puller and remove the

outer axle bearing, 2.

7. Remove the inner bearing race, 1, by driving it

from the housing with a suitable hammer and

8. Remove the outer replaceable seal sleeve, 1, by

prying it from the axle housing.

9. Remove the outer bearing race, 2, and seal, 3, by

driving them from the housing with a suitable

hammer and driver.

Note the positioning of the oil seal before remov-

al, as the replacement seal should be located in

the same position.

SECTION 44 - AXLES AND WHEELS

Chapters

Table of Contents