New Holland LS140 Workshop Manual page 348

2. Install the left pedal assembly, 1, and attach the
front plate with hardware, 2, previously removed.
Do not tighten the hardware at this time.
3. Slide the pedal assembly to align the auxiliary
boom hydraulic hub arm and boom hub arm as
shown. Align the inside edge of each hub arm, 1,
with the slot in the control valve spool, 2. Tighten
the pedal mounting hardware.
4. Recheck the alignment of the hub arm and spool.
5. Install the right pedal, 1, adding shim washers as
necessary so pedal mounting holes line up cor-
rectly. Check that the inside edge of the bucket
hub arm aligns with the slot in the control valve
spool as described above. Install the pedal with
hardware, 2, previously removed, and tighten se-
curely. Connect the two-piece bracket with the
two bolts, 3, washers and nuts.
6. Check for free operation of the foot pedals and
hub control arm assemblies. If any components
are binding, adjust or reshim the pedal assem-
blies.
SECTION 35 - HYDRAULIC SYSTEM
35-79
Copyright © New Holland
1
2
2
1
1
3
135
136
2
137