New Holland LS140 Workshop Manual page 353

Hide thumbs Also See for LS140:

Table of Contents

3. Install the left pedal assembly, 1, and attach the

front plate with hardware, 2, previously removed.

Do not tighten the hardware at this time.

4. Install the boom hub assembly, 3, and bucket hub

assembly, 4, onto the pivot shaft, 5.

5. Slide the pedal assembly to align the auxiliary hy-

draulic hub arm as shown. Align the inside edge

of the hydraulic hub arm, 1, with the slot in the

control valve spool, 2. Tighten the pedal mount-

ing hardware.

6. Recheck the alignment of the hub arm and spool.

7. Check the alignment between the hub arms and

control valve spools. Add shim washers if neces-

sary to correct alignment.

8. Install the right pedal, 1, adding shim washers as

necessary at 2, fitting inside the bearing, 3, so

pedal mounting holes line up correctly. Install the

pedal with hardware, 4, previously removed, and

tighten securely.

9. Check for free operation of the foot pedals and

hub assemblies. If any components are binding,

adjust or reshim the right pedal assembly.

SECTION 35 - HYDRAULIC SYSTEM

Chapters

Table of Contents