New Holland LS140 Workshop Manual page 110

Hide thumbs Also See for LS140:

Table of Contents

Coat head bolt threads with a light coat of

molybdenum disulfide grease.

Tighten the head bolts in three stages in the order

shown. Final torque is 98 - 103 N⋅m (72 - 76 ft. lbs.).

Cap, Push Rod and Rocker Arm Assembly

Install the caps, 1, on the end of the valve stems.

Install the push rods, 2, and rocker arm assembly.

Rocker arm assembly tightening torque:

20 - 25 N⋅m (14 - 18 ft. lbs.).

Install the oil pipe to the front of the cylinder head and

the fitting in the block, 1. Attach the pipe clamp to the

fuel injection pump, 2.

Tighten the banjo bolt fitting to 9 - 12 N⋅m (7 - 9 ft.

SECTION 10 - ENGINE

Chapters

Table of Contents