New Holland LS140 Workshop Manual page 619

Hide thumbs Also See for LS140:

Table of Contents

SECTION 82 - FRONT LOADER (BOOM AND MOUNTING PLATE)

17. Check the hoses through the rear supports, 1.

When the boom is fully raised, position the hoses

in the support as shown and remove any slack

from the boom tubes towards boom clamp, 2.

18. Pull all slack from hoses and tighten the top

clamp, 1. Remove any slack between the clamps

and then tighten the second clamp, 2. When

hoses are routed, make sure that when the boom

is raised and lowered the hoses have enough

loop at 3 to prevent hose stretch between clamp

2 and clamp 4.

19. Install the fenders and raise and lower the boom

checking the hose/tube clearance, 1, to fenders

and readjust if required. Check for any oil leaks

and repair if required.

NOTE: The boom may require several cycles up and

down to remove the air from the boom hydraulic cir-

Chapters

Table of Contents