New Holland LS140 Workshop Manual page 607

SECTION 82 - FRONT LOADER (BOOM AND MOUNTING PLATE)
6. Install the control rod, 1, in the handle assembly,
positioning the wire harness, 2, to the seat front
side of the control rod.
7. Install the control rod, 1, in the handle assembly
and the left boom lock pin, 2. Slide new push re-
taining nuts onto rod at 3, Figures 35 and 36.
8. Slide the plastic handle grip, 1, onto the handle.
9. Operate the control handle to ensure proper op-
eration.
a. Pivot the handle towards the outside of the
operator's cab. The lock pins should extend
from the cab post.
b. Pivot the handle towards the inside of the op-
erator's cab. The lock pins should retract into
the cab post far enough to allow boom move-
ment without contacting the lock pins.
10. Reinstall the engine side shields. Close the top
engine cover and rear door.
2
3
2
82-18
Copyright © New Holland
1
35
1
3
36
37