Hydraulic Oil Filter - New Holland L213 Operator's Manual

Hydraulic oil filter

WARNING
Burn hazard!
Do not handle engine coolant, engine oil, or hydraulic oil at temperatures that exceed 49 °C (120 °F).
Allow fluids to cool before proceeding.
Failure to comply could result in death or serious injury.
Replace the hydraulic oil filter every 500 h of operation or if the warning lamp illuminates.
NOTICE: Replace the hydraulic oil filter after the first 20 h of operation or if a major hydraulic component has been
replaced.
1. Remove any attachments and place the machine on
firm level ground.
2. Open the engine hood.
3. Open the rear service door and engage the rear service
door latch located near the lower hinge.
4. Locate the Hydraulic oil filter (1) to the left of the ra-
diator. See the top figure for radial machines and the
bottom figure for vertical machines.
5. Make sure that the funnel and drain hose are secure.
6. Direct the drain hose into a suitable container.
7. Slowly loosen the hydraulic fill cap (2) to relieve pres-
sure in the system. Leave the cap on, but loose.
8. Clean the area around the hydraulic filter.
9. Turn the hydraulic oil filter counter - clockwise and re-
move. Dispose of the filter properly.
10. Apply a thin layer of clean oil on the O-ring of the new
filter.
11. Install the filter. Hand tighten the filter 1/2 to 3/4 turn
after the filter O-ring touches the filter head.
NOTICE: DO NOT use a filter strap wrench to tighten the
filter. Hand tighten only.
12. Start the engine and check for oil leaks around the
hydraulic filter.
13. Check the fluid level. The oil level should be within the
middle one third of the sight glass. Add oil as required.
14. Unlatch and close the rear service door.
15. Close the engine hood.
7 - MAINTENANCE
7-61
W0330A
1
63109366A
2
93107490