New Holland LS140 Workshop Manual page 511

Op. 55 404 20
ROAD LIGHT AND WORK LIGHT SWITCH
REMOVAL
1. Disconnect the negative (–) battery cable.
2. Remove the switch panel retaining hardware, 1,
and lower the panel.
3. Remove the wires and connector from the switch
terminals.
4. Press in the switch retaining tabs and remove the
switch from the panel.
ROAD LIGHT AND WORK LIGHT SWITCH
INSTALLATION
1. Insert the switch into the panel and insure the
locking tabs secure the switch, 1.
2. Reconnect the wires and connector to the proper
terminals with the PK/B and PK wires toward the
top of the panel.
3. Reattach the switch panel to the overhead dash.
4. Reconnect the negative (–) battery cable.
SECTION 55 - ELECTRICAL SYSTEM
55-86
Copyright © New Holland
100
101