New Holland LS140 Workshop Manual page 177

6. To separate the back plate from the pump hous-
ing, remove the four bolts, 1, and tap the back
plate, 2, with a plastic or rubber mallet to sepa-
rate it from pump housing, 3.
NOTE: The pump housing has two alignment dowel
pins, 1.
There is a replaceable bearing plate located on
the valve plate at 2. Remove the bearing plate
from the back plate.
7. Hold the rotating piston block, 1, in one hand and
tilt the open end of the housing down. Turn the ro-
tating piston block and pull it out as a complete
unit without scratching or burring the parts.
NOTE: Keep the rotating group in an assembly at this
time.
SECTION 29 - HYDROSTATIC TRANSMISSION
29-32
Copyright © New Holland
44
45
46