New Holland LS140 Workshop Manual page 256

Hide thumbs Also See for LS140:

Table of Contents

REMOVAL AND INSPECTION

To access and remove the parking brake control link-

age, the seat can be raised and latched in the raised

position. To access the brake disc and caliper as-

sembly, the final drive inspection cover will need to be

Op. 33 110 48

1. Lower the boom and attachment to the ground.

2. If the work is going to be done with the boom in

the raised position, remove the attachment and

raise the boom and rest on the boom lock pins,

Never work under a raised boom unless it is

properly supported by the boom lock pins.

Never work under a raised boom with an attach-

ment. Always remove the attachment from the

3. Securely block the skid steer with all four wheels

off the ground. Refer to Section 1 for more de-

tailed information on properly supporting the skid

Support the skid steer at the front of the drive

cases at 1, and at the rear at 2.

Failure to securely support the skid steer could

result in movement of the skid steer causing seri-

ous injury or damage to the equipment.

4. Slide the seat to the most rear position, unlatch

the seat pan and raise the seat and pan assem-

bly to the raised latched position.

Before working under a raised seat make sure it

is securely latched at 1, in the raised position.

SECTION 33 - BRAKES AND CONTROLS

Chapters

Table of Contents