New Holland LS140 Workshop Manual page 505

CAB FUSE BLOCK AND PANEL REMOVAL
1. Disconnect the negative (–) battery cable.
2. Remove the panel retaining hardware, 2, and
lower the panel, 1. Removal of the headline
support, 3, will give more access.
3. Unplug the wires from the fuse block.
4. Remove the fuse block retaining hardware.
NOTE: The standard fuse block is part of the main
harness and cannot be completely removed from the
main wire harness and replaced separately.
CAB FUSE BLOCK AND PANEL
INSTALLATION
1. Attach the wires to the proper side of the fuses as
shown at 1, and as shown in the "CAB FUSE
PANEL WIRING" figure above. Check that the
fuses, 2, are in their proper slots.
2. Reinstall the block retaining hardware.
3. Reinstall the panel to the support.
4. Reinstall headliner support, if removed.
5. Reconnect the negative (–) battery cable.
SECTION 55 - ELECTRICAL SYSTEM
19997757
55-80
Copyright © New Holland
3
1
2
89
90