New Holland LS140 Workshop Manual page 236

DISASSEMBLY
1. Take note of the number and position of all shim
washers for reassembly.
2. Remove the bolt, 1, securing the ball end to the
control arm.
3. Remove the jam nut, 2, and ball end, 3, from the
rod, 4.
4. Remove the groove pin, 5, from the arm, 6.
5. Loosen the set screw, 7, on the set collar.
6. Remove the cotter pins, 8, and shim washers, 9,
taking note of the number of shim washers for
reassembly.
7. Remove the bearings, 10, from the control han-
dle and the bearings, 11, from the handle mount-
ing plates. Slide the handle sideways and re-
move from the stub shafts.
Op 29 100 15
Auxiliary Boom Control Handle (only)
8. Boom hydraulics control - Remove the setscrew,
1, and remove the handle support, 2, and control
rod, 3, from the handle tube, 4.
9. Boom hydraulics control - Remove the roll pin, 1,
the L-pin, 2, and the spring and ball at 3.
SECTION 29 - HYDROSTATIC TRANSMISSION
29-91
4
10
11
7
1
19996890
19997746
Copyright © New Holland
2 3
10
1
8
9
11
9
8
6 5
199
3
2
4
200
3
2
1
201