New Holland LS140 Workshop Manual page 206

8. Reinstall the pistons and piston plate, 1, and
spherical washer (pivot), 2, into the piston block,
3. Make sure the pivot is resting squarely on the
loading pins, 4.
9. Invert the motor housing, 2, and insert the rotat-
ing group assembly, 1, into the housing.
NOTE: Piston shoes must contact the camplate. Be
sure all parts are in their proper position before pro-
ceeding.
NOTE: If the rotating group assembly will not easily
slide over the splined shaft, DO NOT FORCE. One
or more of the three loading pins may be out of their
groove or the pin head is not seated properly be-
tween the washer and block. Forcing the rotating
group may cause pin failure and early transmission
failure.
IMPORTANT: Make sure all mating surfaces are well
lubricated with SAE 10W-30 motor oil to insure prop-
er lubrication for start-up.
10. Backplate
If required, install a new needle bearing, 1, in the
backplate. The bearing should be installed with
the numbered end facing the center of the motor
assembly.
SECTION 29 - HYDROSTATIC TRANSMISSION
29-61
Copyright © New Holland
123
124
125