New Holland LS140 Workshop Manual page 257

Hide thumbs Also See for LS140:

Table of Contents

5. Remove the tires and wheels from the final drive

and brake being serviced.

6. Clean the axle and final drive area to prevent de-

bris from entering the final drive case.

7. Loosen the eight axle housing retaining nuts and

washers, 1, on the rear axle and slide the axle for-

ward to loosen the drive chain.

8. Remove the fender retaining hardware at 2, and

remove the fender to access the spring and link-

9. Remove the final drive case center cover, 3.

Op. 33 110 14

Brake Control Linkage Removal

1. Remove the handle retaining bolts, 1, slide the

handle, button and spring, and latch plate as-

sembly, 2, from the link, 3.

Note the positioning of the internal latch plate for

Op. 33 110 30

2. To remove the control rod assembly, 1, remove

the cotter pins from the spring links, 2.

3. Remove the left support bracket, 3, and hard-

ware, then pivot the rod assembly down and slide

the control rod from the right support bracket.

Remove the pivot bushings from supports and

friction pad from rod.

4. Remove the lower cotter pin, 4, and remove the

spring assemblies, 5, from the brake caliper ac-

SECTION 33 - BRAKES AND CONTROLS

Chapters

Table of Contents