Wire Harness; Main Wire Harness Removal - New Holland LS140 Workshop Manual

Hide thumbs Also See for LS140:

Table of Contents

WIRE HARNESS

Op. 55 100 74

1. Remove any attachment from the loader

attaching plate.

2. Raise the boom and support on the boom lock

3. Stop the engine, turn the ignition key to the

"RUN" position and operate the boom and bucket

controls to relieve pressure in the boom and

bucket circuits. Turn "OFF" the key.

Never work under a raised boom unless it is

properly supported by the boom lock pins. Never

work under a raised boom with an attachment.

Always remove the attachment from the loader.

4. Disconnect the negative (–) battery cable, 1.

5. Remove the left fender, 1; retaining hardware, 2;

and remove fender.

SECTION 55 - ELECTRICAL SYSTEM

Table of Contents