New Holland LS140 Workshop Manual page 266

9. Install the brake disc retaining ring, 1. Check to
make sure the brake caliper center section, 2,
and brake discs, 3, are free to move when the
brakes are released.
10. Thread shaft, 1, into support, 2, and remove all
play in the brake caliper and disc.
11. Rotate and position control arm, 3, so the spring
link can be reconnected at 4.
a. Slide the control arm onto the shaft.
b. Position the control arm on the shaft for clear-
ance between arm and other components
when the brake is engaged and disengaged.
c. Tighten the retaining screw, 5, in the control
arm. Tighten the jam nut.
d. Install cotter pin in spring link at 4.
12. Reinstall the drive chain over the drive sprocket
at 1.
SECTION 33 - BRAKES AND CONTROLS
33-19
Copyright © New Holland
40
41
42