SECTION 82 - FRONT LOADER (BOOM AND MOUNTING PLATE)
3. Weld is high carbon steel (tooth) to high carbon
steel (bucket). Use welding rods marked 7018 or
comparable rods. Weld on both sides of the tooth
from the back of the tooth towards the replace-
able point.
4. Stop welding 13 mm (1/2") from the cutting edge
as noted. A minimum 5 mm (3/16") fillet weld is
required for this application.
5. Weld in the direction shown, at 1.
6. Weld a 5 mm (3/16") bevel groove weld, 2, on
both sides of the tooth, high carbon steel to high
carbon steel.
82-15
Copyright © New Holland
5 mm
(3/16,)
5 mm
13 mm
(3/16,)
(1/2,)
28
29