New Holland LS140 Workshop Manual page 63

Hide thumbs Also See for LS140:

Table of Contents

Pull the tappets from the machined bore in the

cylinder block.

Op. 10 223 10

STOP SOLENOID

Unscrew the stop solenoid.

Reach into the solenoid mounting hole and press the

fuel pump rack into the pump.

Op.10 236 10

FUEL INJECTION PUMP

1. Remove the bolts and nuts securing the fuel

injection pump to the cylinder block. Slowly lift

and position the fuel injection pump until access

to the link snap pin is gained.

2. Remove the snap pin and remove the link from

the control rack. Remove the fuel injection pump

and shim pack.

NOTE: Injection timing is determined by the shim

pack between the fuel injection pump flange and

cylinder block mounting face. The thickness and

number of shims should be checked and recorded to

aid reassembly.

SECTION 10 - ENGINE

Chapters

Table of Contents