New Holland LS140 Workshop Manual page 138

6. Remove the spring from one of the valves in No.1
cylinder.
7. Gently tap the end of the valve stem to remove
loose carbon from the valve head.
8. Install a dial indicator, 1, with the pointer resting
on the end of the valve stem, 2.
9. Install a temporary, gravity feed fuel supply to the
injection pump.
10. Turn the crankshaft clockwise to bring the piston
to top-dead-center on the compression stroke.
11. Set the dial indicator to zero.
12. Turn the crankshaft counterclockwise until the
dial indicator reads 5.477 mm (0.216"). Be sure
the valve follows the piston down.
13. Open the fuel supply. Fuel should flow from the
No. 1 delivery valve holder.
14. Slowly turn the crankshaft clockwise until fuel
flow stops. Observe the dial indicator reading.
SECTION 10 - ENGINE
10-103
Copyright © New Holland
171