New Holland LS140 Workshop Manual page 322

REINSTALLATION
1. Place the rubber isolation mount, 1, in place un-
der the control valve space.
2. Reinstall the control valve into the skid steer with
the retaining hardware previously removed.
Align the valve with the control linkage and
torque the valve retaining hardware to 24 N·m
(18 ft. lbs..).
3. Reconnect the control linkage and wiring har-
ness to the lockout solenoids.
4. Reinstall the hydraulic lines and tighten to seat
the fittings, then loosen the lines and retorque.
5. Refill the hydraulic reservoir with 10W-30 oil.
6. With the unit supported off the ground, start the
unit and check for any oil leaks and repair.
7. Reinstall the step shield and belly pan.
8. Recheck the hydraulic oil level and add as re-
quired.
SECTION 35 - HYDRAULIC SYSTEM
19984464
35-53
1
Copyright © New Holland
2
69