Labor Guide - New Holland LS140 Workshop Manual

LABOR GUIDE

The following labor amounts are listed as a guide only. Working conditions and experience will vary the time it
actually takes to complete each job.
Job Description
Air filter sensor, remove and replace
Alternator, remove and replace
Battery, remove and replace
Electronic instrument cluster
Engine coolant sensor, remove and replace
Engine oil pressure sender, remove and replace
Fuel level sender, remove and replace
Fuel shutoff solenoid, remove and replace
Hydraulic oil temperature sensor, remove and replace
Hydraulic oil filter sensor, remove and replace
Hydrostatic charge pressure sensor, remove and replace
Ignition (key) switch, remove and replace
Light (road/work) switch, remove and replace
Preheat manual switch, remove and replace
Preheat circuit breaker, remove and replace
Preheat relay, remove and replace
Resistor, alternator charge circuit, remove and replace
Road/work/taillight bulb, remove and replace
Seat belt (buckle) switch, remove and replace
Seat switch(es), remove and replace
Service/run switch, remove and replace
Solenoid, control valve spool locks, remove and replace
Start interlock relay, remove and replace
Starter, remove and replace
Starter relay, remove and replace
Wire harness (main), remove and replace
Wire harness (engine), remove and replace
Wire harness (seat/seat belt), remove and replace
SECTION 55 - ELECTRICAL SYSTEM
55-164
Copyright © New Holland
Hours
0.5
0.5
0.25
0.25
0.25
0.25
0.5
0.25
2.0
0.5
0.5
0.25
0.25
0.5
0.5
0.5
0.5
0.25
0.25
0.5
0.5
0.5
0.5
1.0
0.5
6.0
1.5
1.0