Table of Contents
Advertisement
F
C
M
ILE AND
ONFIGURATION
ANAGEMENT
COPY DEBUG
copy debug
Overview
This command copies a specified debug file to a destination file. Specify whether
the destination is Flash or USB when saving the software to the local filesystem.
copy debug {<destination-name>|debug|flash|nvs|scp|tftp|usb}
Syntax
{<source-name>|debug|flash|nvs|scp|tftp|usb}
Mode
Privileged Exec
Example
To copy debug output to a USB storage device with a filename "my-debug", use
the following command:
awplus#
Output
Figure 2-2:
Related
delete debug
Commands
move debug
C613-50103-01 REV A
C
OMMANDS
Parameter
<destination-name>
<source-name>
copy debug usb:my-debug
CLI prompt after entering the copy debug command
Enter source file name []:
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
The filename and path where you would like the debug
output saved. See
Introduction
The filename and path where the debug output originates.
See
Introduction
on page 99 for valid syntax.
on page 99 for valid syntax.
114
Advertisement
Table of Contents
