Debug Gvrp - Allied Telesis IE340 Series Command Reference Manual

GVRP C
OMMANDS

DEBUG GVRP

debug gvrp
Overview Use this command to debug GVRP packets and commands, sending output to the
console.
Use the no variant of this command to turn off debugging for GVRP packets and
commands.
Syntax debug gvrp {all|cli|event|packet}
no debug gvrp {all|cli|event|packet}
Mode Privileged Exec and Global Configuration
To enable GVRP on interfaces port1.0.1-port1.0.2, enter the commands:
Examples
awplus#
awplus(config)#
awplus(config)#
awplus(config-if)#
To disable GVRP on interfaces port1.0.1-port1.0.2, enter the commands:
awplus#
awplus(config)#
awplus(config-if)#
Examples To send debug output to the console for GVRP packets and GVRP commands, and
to enable the display of debug output on the console first, enter the commands:
awplus#
awplus#
awplus(config)#
To send debug output for GVRP packets to the console, enter the commands:
awplus#
awplus#
awplus(config)#
C613-50631-01 Rev A
Parameter Description
all
Specifies debugging for all levels.
cli
Specifies debugging for commands.
event Specified debugging for events.
packet
Specifies debugging for packets.
configure terminal
gvrp enable
interface port1.0.1-port1.0.2
configure terminal
interface port1.0.1-port1.0.2
terminal monitor
configure terminal
debug gvrp all
terminal monitor
configure terminal
debug gvrp packets
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
gvrp
no gvrp
840