Show Config - Dell Force10 Z9000 Reference Manual

Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Usage STP is not enabled when you enter SPANNING TREE mode. To enable STP globally on the
Information switch, use the no disable command from SPANNING TREE mode.
Example
FTOS(conf)#protocol spanning-tree 0
FTOS(config-stp)#
Related disable
Commands disable command.

show config

Display the current configuration for the mode. Only non-default values are displayed.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax show config
Command Modes SPANNING TREE
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Example
FTOS(config-stp)#show config
protocol spanning-tree 0
FTOS(config-stp)#
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– disables spanning tree group 0. To enable spanning tree group 0, use the no
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
no disable
1417