Show Interface Dei-Honor - Dell Force10 Z9000 Reference Manual

Defaults Not configured.
Command Modes CONF-IF-VLAN
Command History
Version 8.3.11.1
Version 8.2.1.0
Version 7.6.1.0
E-Series original
Command
Usage You must enable the stackable VLAN (using the vlan-stack compatible command) on
Information
the VLAN prior to adding a member to the VLAN.
Related vlan-stack compatible
Commands

show interface dei-honor

Display the dei honor configuration.
C-Series, S-Series
Syntax show interface dei-honor [interface slot/port | linecard number
port-set number]
Parameters
interface slot/port
linecard
port-set
Command Modes EXEC Privilege
Command History
Version 8.3.1.0
Example
FTOS#show interface dei-honor
1448
• For a Port Channel interface, enter the keywords port-
channel followed by a number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale and 1 to 512 for ExaScale.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabyte Ethernet interface, enter the keyword
fortyGigE followed by the slot/ port information.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the C-Series and S-Series.
– enables stackable VLAN on a VLAN.
Enter the interface type followed by the line card slot and port
number.
number
Enter linecard followed by the line card slot number, then enter
number
port-set followed by the port-pipe number.
Introduced on the C-Series and S-Series.