[49] Acct-Terminate-Cause; [50] Acct-Multi-Session-Id; [51] Acct-Link-Count - Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual

[49] Acct-Terminate-Cause

Use the following command to manage the Acct-Terminate-Cause RADIUS attribute.
radius include acct-terminate-cause

[50] Acct-Multi-Session-Id

Use the following command to manage the Acct-Multi-Session-Id RADIUS attribute.
radius include acct-multi-session-id

[51] Acct-Link-Count

Use the following command to manage the Acct-Link-Count RADIUS attribute.
Example
host1(config)#radius include acct-authentic acct-on enable
Use the no version to restore the default, enable.
radius include acct-terminate-cause
Use to include the Acct-Terminate-Cause attribute in Acct-Off messages.
You can control inclusion of the attribute by enabling or disabling this command.
See radius include.
Example
host1(config)#radius include acct-terminate-cause acct-off disable
Use the no version to restore the default, enable.
radius include acct-multi-session-id
Use to include the Acct-Multi-Session-Id attribute in Access-Request, Acct-Start,
or Acct-Stop messages.
You can control inclusion of the Acct-Multi-Session-Id attribute by enabling or
disabling this command.
See radius include
Example
host1(config)#radius include acct-multi-session-id acct-stop disable
Use the no version to restore the default, enable for accounting messages and
disable for access requests.
Chapter 3: Configuring RADIUS Attributes
CLI Commands Used to Modify RADIUS Attributes
207