Table of Contents
Advertisement
Limit Electromagnetic Interference
For best operation, keep the Alcatel OmniAccess 4302 WLAN Switch and all
cords and cables at least 0.7 meters (2 feet) from fluorescent lighting fixtures, and
2 meters (6 feet) from photocopiers, radio transmitters, electric generators, and
other sources of strong electromagnetic interference.
Alcatel recommends that you do not stack multiple Alcatel OmniAccess 4302
WLAN Switchs or place other devices on the top of the unit. However, if you
must stack devices, make sure that adequate space exists between units to allow
for air flow to keep the Alcatel OmniAccess 4302 WLAN Switch within operation
temperature limits. At a minimum, make sure the upper unit has its rubber feet
attached.
Connecting Power
Use the power adapter supplied with the Alcatel OmniAccess 4302 WLAN
Switch. Do not substitute power adapters designed for other products as this
may damage the device or the power adapter.
F
2-1
IGURE
To power the Alcatel OmniAccess 4302 WLAN Switch:
1.
Insert the DC connector into the power port on the rear of the Alcatel
OmniAccess 4302 WLAN Switch.
2.
Connect the power cord to the power adapter and plug this into a standard
grounded outlet.
Power Adapter
Installing the Chassis
DC C
ONNECTOR
OmniAccess 4302 WLAN Switch
Installation Guide
Chapter 2
9
Advertisement
Table of Contents
