Selecting The Security Violation Mode; Restoring The Operational State Of An Lps Port - Alcatel OmniSwitch 6600 Family Network Configuration Manual

Selecting the Security Violation Mode

Selecting the Security Violation Mode
By default, the security violation mode for an LPS port is set to restrict. In this mode, when an unautho-
rized source MAC address is received on an LPS port, the packet containing the address is blocked.
However, all other packets containing an authorized source MAC address are still allowed on the port.
Note that unauthorized source MAC addresses are not learned in the LPS table but are still recorded in the
source learning MAC address table with a filtered operational status. This allows the user to view MAC
addresses that were attempting unauthorized access to the LPS port.
The other violation mode option is shutdown. In this mode, the LPS port is disabled when an unautho-
rized MAC address is received; all traffic is prevented from forwarding on the port.
To configure the security violation mode for an LPS port, enter port-security followed by the port's
slot/port designation, then violation followed by restrict or shutdown. For example, the following
command selects the shutdown mode for port 1 on slot 4:
-> port-security 4/1 violation shutdown
To configure the security violation mode for multiple LPS ports, specify a range of ports or multiple slots.
For example:
-> port-security 4/1-10 violation shutdown
-> port-security 1/10-15 2/1-10 violation restrict

Restoring the Operational State of an LPS Port

After a security violation occurs, the LPS port is either administratively disabled or is filtering traffic from
one or more source MAC address. To return the port to normal operation without having to manually reset
the port and/or module, use the
-> port-security 4/1 release
-> port-security 1/10-15 2/1-10 release
When this command is used, all MAC addresses known to the specified port are flushed from the switch
MAC address table.
Note. Using the port-security release command restores the port to the same operational state it was in
prior to the security violation. This includes the activation of any existing LPS configuration for the port,
LPS monitoring of the port is automatically restored.
page 3-10
port-security release command. For example:
OmniSwitch 6600 Family Network Configuration Guide
Configuring Learned Port Security
April 2006